Do You Have A Squeaky Shower Door?

There is nothing more annoying than a squeaky door.

Especially when you are trying to keep the noise down.

The old saying goes – ‘The squeaky wheel gets the oil’, yet even though it may be driving us crazy every time we hear it, we tend to put it off or forget about it until we open the door the next day!

The changing seasons here in Queensland and Northern New South Wales, means doors can start squeaking from corrosion of salt water spray.

Squeaky shower screens can squeal due to their humid conditions, poor quality doors can swell when damp or even just some loose screws can make all the difference to the free flow of a door.

So how can we fix those squeaky doors, once and for all?  Do we have to replace the door to stop the noise?

The solutions can be simpler than we think; it’s a matter of knowing what to look for. So let’s take you a through a few easy steps to see what we can do to save those annoying doors –

Check Your Shower Door Hinges

The first thing you should do is look at the door hinge and see if this is part of the problem.

Make sure all hardware is in place and check for loose screws.

Go ahead and tighten any that may be loose and this could help with the problem.

You can also clean the hinges with a little soap and water.

Using a small brush, like an old toothbrush, is the best way to clean in the small crevices.

Once they are clean rinse with water. If the squeak is already gone, it’s important to continue to the next step for longevity and prevention.

Use a Lubricant

After cleaning the hinges it’s important to protect them from further corrosion.

So lubricate them well. Apply the lubricant completely around the whole hinge.

Wipe away any excess and open and close the door several times, this will help the lubricant to spread completely.

Your shower door should now operate without any squeaky noises.

To keep your hinges from squeaking in the future you should apply a lubricant every few weeks.

What To Do If The Doors Are Still Squeaking?

If the steps above didn’t work for you, you will need to do a more thorough cleaning.

Check the entire door frame for any obvious problems with any missing parts.

Also, if you find any dirt and built-up grime you can use the same method as stated above, use a toothbrush with mild soap to clean the door frame. Wipe clean thoroughly.

You can also remove built-up corrosion to help aid in fixing your squeaky door.

Place a few towels under the door in and outside of the shower door frame.

You can then use the shower spray to go over all hinges and areas around it as well.

The water pressure from the spray will penetrate inside of the small crevices and loosen up any corrosion.

Think it’s time to completely update the shower screen and need some advice?

GlassNow sell new shower screens throughout Qld and service from Tweed Heads to Northern Brisbane with Glass Shower screens.

You may also find our previous post of interest to you: